
Polypropylene fine denier features tiny single‑filament linear density and is highly sensitive to spinneret condition during spinning. Many purchasers only check denier and tenacity test data of finished yarn and pay little attention to hidden risks induced by spinneret. Even with identical raw materials and process parameters, minor spinneret abnormalities cause filament breakage, coalesced filaments and large denier dispersion, bringing hidden troubles for downstream knitting and weaving.
Inner‑hole finish of spinneret determines melt extrusion status. Scratches and deposits inside micro‑holes disturb melt flow and result in uneven single‑filament thickness. Abnormally thin filaments inside Polypropylene fine denier tend to break under weaving tension and generate fabric fuzz defects. Carbon deposits hanging around hole edges lead to coalesced filaments, several monofilaments stick together and cannot be separated, causing continuous end‑breakage during weaving.
Micro‑hole blockage is a frequent issue for fine‑denier spinning. Foreign particles reduce local melt throughput and produce extra‑thin filaments with uneven stress inside yarn bundle. Spinneret cleaning cycle for Polypropylene fine denier cannot copy parameters for ordinary PP multifilament. Insufficient cleaning amplifies defects, while improper cleaning damages inner hole surface and triggers recurring quality problems after re‑installation.
Spinneret selection shall match fine‑denier production. Hole diameter and length‑diameter ratio need to adapt to polypropylene melt fluidity. Melt swell becomes unstable with mismatched dimension and target fine‑denier specification can hardly be achieved. Equipped with imported spinning equipment, Zhejiang Oriental Sun Fibre Ltd. implements standardized procedure for spinneret disassembly, cleaning and inspection to reduce coalesced filaments and abnormal monofilaments and guarantee batch consistency of Polypropylene fine denier.
Besides routine physical‑chemical tests during sampling, downstream manufacturers are suggested to run long‑time weaving trial to check fuzz and breakage, identify hidden yarn defects from spinneret and avoid mass‑production risks.


